Case studies on the performance and characterisation of the froth phase in industrial flotation circuits

Abstract

This paper deals with two separate case studies investigating the froth phase performance and characterisation of two industrial rougher/scavenger flotation circuits. Froth phase performance was quantified using a mass balance approach to estimate froth zone recovery. Measured characteristics of the froth phase included frother solution concentration determined by gas chromatography, and the time taken for an equilibrium froth sample to decay to one-half of its original froth height. The latter measurement is referred to as the 'froth half-life' and is strongly linked to froth stability. Special methods and techniques developed to preserve frother in solution and to measure froth half-life are briefly described. The frother type in the first case study was a mixture of straight and branched alcohols, whilst the frother type in the second case study was a mixture of alcohols, aldehydes and triethoxybutane. The first case study focussed on a flotation circuit treating a low grade ore containing only a small fraction of floatable copper sulphide minerals, while the second case study focussed on a flotation circuit treating a higher grade complex sulphide ore containing significant quantities of chalcopyrite, galena, sphalerite and pyrite. It was found that froth zone recovery of valuable mineral generally decreased down-the-bank of the two industrial rougher/scavenger circuits. Moreover, decreases in froth zone recovery significantly limit the overall cell recovery of valuable mineral achievable from the plant scavenger cells. However, the decrease in froth zone recovery could not be linked to the removal of frother from the pulp solution to the concentrate product in the preceding rougher flotation stages. Measurements of residual frother in solution suggested that, approximately, only 5-10% of the added frother was removed into the rougher/scavenger concentrate, with the remainder appearing in the scavenger tailings. This finding suggested there was apparently adequate frother in solution in the scavenger stages. There was, however, a correlation to the froth half-life, with the froth half-life also generally decreasing down-the-bank. A simple, empirical model, based on the froth half-life and froth residence time of gas, is proposed here to predict froth zone recovery. Further, it is proposed that the froth stability, as measured by the froth half-life, is strongly linked to the presence of particles in the froth, with poorly mineralised scavenger froth characterised by a short half-life and, potentially, a low froth zone recovery. The importance of particles on froth stability was confirmed in separately conducted laboratory experiments. These experiments also demonstrated the wide variation in froth stability behaviour between different frother types. © 2005 Elsevier Ltd. All rights reserved.